U-Boot 1.1.3 (Jan 12 2011 - 21:35:28) (ALPHA) SVN revision: 482 Target board: WRG-N23 Board: Ralink APSoC DRAM: 32 MB config usb..*** Error: D+/D- is 1/1, config usb failed. ..*** Error: D+/D- is 1/1, config usb failed. Set info->start[0]=BF000000 ============================================ Ralink UBoot Version: 3.5.1.0 -------------------------------------------- ASIC 3052_MP2 (Port5<->None) DRAM component: 256 Mbits SDR DRAM bus: 16 bit Total memory: 32 MBytes Flash component: NOR Flash Date:Jan 12 2011 Time:21:35:28 ============================================ icache: sets:256, ways:4, linesz:32 ,total:32768 dcache: sets:128, ways:4, linesz:32 ,total:16384 ## Powering down port 0 ~ 3. Please choose the operation: 1: Load system code to SDRAM via TFTP. 2: Load system code then write to Flash via TFTP. 3: Boot system code via Flash (default). 4: Entr boot command line interface. 7: Load Boot Loader code then write to Flash via Serial. 9: Load Boot Loader code then write to Flash via TFTP. 0 3: System Boot system code via Flash. ## Booting image at bf050000 ... Image Name: Linux Kernel Image Created: 2011-09-15 6:35:23 UTC Image Type: MIPS Linux Kernel Image (lzma compressed) Data Size: 878062 Bytes = 857.5 kB Load Address: 80000000 Entry Point: 802b5000 Verifying Checksum ... OK Uncompressing Kernel Image ... OK Starting kernel ... Linux version 2.6.21 (eric@localhost.localdomain) (gcc version 3.3.5) #1 Thu Sep 15 10:48:25 CST 2011 The CPU feqenuce set to 320 MHz CPU revision is: 0001964c Determined physical RAM map: memory: 02000000 @ 00000000 (usable) Built 1 zonelists. Total pages: 8128 Kernel command line: console=ttyS1,57600n8 root=/dev/mtdblock1 noinitrd Primary instruction cache 32kB, physically tagged, 4-way, linesize 32 bytes. Primary data cache 16kB, 4-way, linesize 32 bytes. Synthesized TLB refill handler (20 instructions). Synthesized TLB load handler fastpath (32 instructions). Synthesized TLB store handler fastpath (32 instructions). Synthesized TLB modify handler fastpath (31 instructions). Cache parity protection disabled arch_init_irq: cause = 80800028, status = 1100ff00 PID hash table entries: 128 (order: 7, 512 bytes) mips_time_init: calculating r4koff ... 0x00138800 (1280000) CPU frequency 320.00 MHz Using 160.000 MHz high precision timer. Console: colour dummy device 80x25 Dentry cache hash table entries: 4096 (order: 2, 16384 bytes) Inode-cache hash table entries: 2048 (order: 1, 8192 bytes) Memory: 29408k/32768k available (2269k kernel code, 3360k reserved, 498k data, 116k init, 0k highmem) Mount-cache hash table entries: 512 NET: Registered protocol family 16 Time: MIPS clocksource has been installed. NET: Registered protocol family 2 IP route cache hash table entries: 8192 (order: 3, 32768 bytes) TCP established hash table entries: 1024 (order: 1, 8192 bytes) TCP bind hash table entries: 1024 (order: 0, 4096 bytes) TCP: Hash tables configured (established 1024 bind 1024) TCP reno registered squashfs: version 3.2-r2 (2007/01/15) Phillip Lougher squashfs: LZMA suppport for slax.org by jro io scheduler noop registered io scheduler deadline registered (default) FLASH_API: **********<>************** FLASH_API: Flash Not Support(MAN_ID=FF DEV_ID=7E0000) FLASH_API: **************************************** rt3052 access driver initialization. Ralink gpio driver initialized HDLC line discipline: version $Revision: 1.1.1.1 $, maxframe=4096 N_HDLC line discipline registered. Serial: 8250/16550 driver $Revision: 1.3 $ 2 ports, IRQ sharing disabled serial8250: ttyS0 at I/O 0xb0000500 (irq = 37) is a 16550A serial8250: ttyS1 at I/O 0xb0000c00 (irq = 12) is a 16550A ra2880_read_mac: 00:00:00:00:00:00 ra2880_read_mac: 00:00:00:00:00:00 Ralink APSoC Ethernet Driver Initilization. v1.60 256 rx/tx descriptors allocated, mtu = 1536! ra2880_read_mac: 00:00:00:00:00:00 ra2880_read_mac: 00:00:00:00:00:00 PPP generic driver version 2.4.2 PPP BSD Compression module registered PPP MPPE Compression module registered NET: Registered protocol family 24 elbox physmap platform flash device: 00400000 at bfc00000 elbox-flash elbox-flash.0: map_probe failed u32 classifier ip_conntrack version 2.4 (256 buckets, 2048 max) - 256 bytes per conntrack ip_conntrack_pptp version 3.1 loaded ip_conntrack_rtsp v0.6.21 loading net/ipv4/netfilter/ip_conntrack_rtsp.c: init: port #0: 554 net/ipv4/netfilter/ip_conntrack_rtsp.c: init: port #1: 557 ip_nat_pptp version 3.0 loaded ip_nat_rtsp v0.6.21 loading ip_tables: (C) 2000-2006 Netfilter Core Team, Type=Linux ipt_time loading TCP cubic registered NET: Registered protocol family 1 NET: Registered protocol family 17 802.1Q VLAN Support v1.8 Ben Greear All bugs added by David S. Miller VFS: Cannot open root device "mtdblock1" or unknown-block(0,0) Please append a correct "root=" boot option Kernel panic - not syncing: VFS: Unable to mount root fs on unknown-block(0,0)